ergo.® 1307

Bonding Technology

This low odor ergo® - grade was developed to bond metals like aluminum, steel, brass and its alloys as well as ferrite, a wide range of plastics and combinations of those materials.

It is a two-component system and cures after mixing into a dry, high-strength and impact resisting polymer film. The best mixture-ratio is 1:1 (volume) and is obtainable without problems by using the common double-cartridges.

Advantages

  • Fast curing system
  • High tensile shear strength
  • Resists against impacts as well as again peeling
  • Good gap-filling behaviour up to 0,10mm
  • Free of solvents
  • Short fixture times
  • Passes test acc. to UL-94 HB at layer thickness of 3 mm
Product Info
>Kisling AG Kisling AG
Bonding Technology

Features

Thermoplastics
PA
PA (PA 6)
PA (PA 6.6)
PBT
PC
PES
PET
PEEK
PMMA
PVC (harder perfomance)
Thermoplastics (Styrenes)
ABS
ASA
PS
SAN
Thermosetting Plastics
EP
MF
PF
PUR (higher degree of cross-linking)
UP
Thermosets (Composites)
CRP
BMC
FR4
GRP
SMC
Elastomers
NBR
Metals - susceptible to corrosion (active)
bronze
cast iron
copper
magnesium
brass
steel (blasted SA 2,5)
Metals - anti corrosive surfaces (passive)
aluminium
plumb
chromium
gold
nickel
magnets
platinum
silver
silicium
steel - chromated
steel - stainless steel
steel - galvanised
titanium
zinc (also galvanized materials)
tin
Glass & Ceramic Materials
emaille
glass
ceramics
ceramic (techno-)
mosaic & tiles
porcelain
Wood & Timber
solid timber - untreated
Paper & Cardboard
alu-coated materials
Anchoring & Fixing
chemical anchoring systems
screw thread - through hole
screw thread - pocket hole bore
chemical screw retention
2-part systems
methylmethacrylate
Solvents
solvent-free
fire protection classification
UL 94 HB
Sector classification
manufacuting industry
Temperature resistance <0°C (approx.)
from -40°C
Temperature resistance >0°C (approx.)
to +120°C
Shore-D
Sh-D 61 to 80
Deformation capability
≤ 30%
Gap filling properties
≤ 1mm
Curing mechanisms
room temperature curing
Pot life @ +20/23°C - Minimum / minutes
1-5 min
(Mixed) viscosity
high viscosity
Packaging unit
cartridge (1- or 2-part)
Liquid Adhesives
2-part systems

Contact Form

The search results from SUBSTRATEC are not sales recommendations and/or professional technical advice. It is only intended to make it easier for the user to pre-select suitable adhesives that may be available. SUBSTRATEC gives no guarantee that the adhesive suggested is successful or suitable for the specific area of application of the user. In the event of any questions regarding the use and suitability for the specific application, the user has the possibility to directly contact the respective technical contact person of the relevant adhesive manufacturer or supplier. See for further information Terms of Use.